How To Handle Basic Operations; Picture Adjustment - JVC TM-2100PN Instrucciones

HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
1. Press the POWER switch to turn on the power.
ON
OFF
POWER
2. Press the INPUT SELECT button to choose input.
B A
Y/ C VIDEO VIDEO
INPUT SELECT
3. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
– +
VOLUME/SELECT

PICTURE ADJUSTMENT

1. Press select button corresponding to the item you
want to adjust.
PHASE CHROMA BRIGHT CONTRAST
2. Adjust with the VOLUME/SELECT buttons.
– +
VOLUME/SELECT
6
LCT0053-002A-H (EN)
_ON : Power turns ON. (Power indicator: lit)
—OFF : Power turns OFF. (Power indicator: unlit)
Selects video/audio signals input to terminals on the rear
panel.
INPUT
Terminals on the rear panel
SELECT
Video signal input
button
1
Input A
VIDEO A terminal
(VIDEO)
2
Input B
VIDEO B terminal
(VIDEO)
3
Input B
VIDEO B (Y/C) terminal
(Y/C)
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (00 = 50)
– : The Built-in speaker volume is decreased. (50 = 00)
* Screen indication will disappear about 10 seconds after
operating.
The item you select is displayed on the screen.
1
PHASE ( ) : Phase control
2
CHROMA ( ) : Chroma control
3
BRIGHT ( ) : Brightness control
4
CONTRAST ( ) : Contrast control
VOLUME/SELECT button
Items
PHASE
reddish
(Phase)
CHROMA
lighter
(Chroma)
BRIGHT
darker
(Brightness)
CONTRAST
lower
(Contrast)
* Screen indication will disappear about 10 seconds
after operating.
6
Audio signal input
AUDIO A terminal
AUDIO B terminal
– +
greenish
deeper
brighter
higher
02.07.30, 2:45 PM
Colour system indication
(PAL or NTSC)
PAL
With regard to Colour system indication
● With the COLOR SYSTEM setting set
to AUTO mode, when you turn on the
power or select inputs, the colour
system indication appears for about 3
seconds on the screen while PAL or
NTSC signals are being detected.
It does not appear when receiving B/
W signal or when no signal is input.
See page 7 for COLOR SYSTEM
setting.
00 ~ 50
VOLUME : 20
+
–
–20 ~ +20
PHASE : 00
– +
Notes:
● Phase control is effective only in the
NTSC colour system mode.
● Chroma control is not effective when
receiving B/W or when no signal is
input.
● When the Chroma control is set to
level " –20", the picture turns
monochrome.
● "NO EFFECT" is displayed (For about
3 seconds) when your selected
function has no effect.