Tool it PBT 60 Manual De Instrucciones página 8

PBT 600 – Battery Conductance Testeur
9. Battery Test Result
Battery test result includes 5 types as following:
1. Good battery
SOH:96% SOC:98%
12.64V 490A
Rating 500A
GOOD BATTERY
The battery is without any problem,
please be relaxed to use!
3. Replace
SOH:46% SOC:80%
12.68V 340A
Rating 500A
REPLACE
The battery is near to or already reached the
end of the using life, replace battery, otherwise,
bigger danger will be followed.
5. Charge, retest
Unstable battery shall be recharged and retested
to avoid error, if same test result appears after
recharge and retest, the battery is regarded as
damaged,replace the battery.
NOTE: If "Replace" resulted from IN-VEHICLE mode, it might be the reason that
vehicle cable is not well connected with the battery.Ensure to cut off the cable and
retest the battery under OUT-OF-VEHICLE before making a decision to replace
battery.
After testing,if need to return, press RETURN key to directly return to the startup
interface.If it is "OUT-OF-VEHICLE" test state, press OK key, it will print the test result.
If it is "IN-VEHICLE" test state, press OK key will bring to Cranking Test.
10. Cranking Test
● Connect with current clamp in advance. Under bad connection,
tester will not test the actual cranking amps accurately.
● Starting the engine as prompted, tester will automatically
complete the cranking test and display the result.
2. Good, recharge
SOH:78%
12.20V
Rating
GOOD, RECHARGE
Good battery but low current,
recharge before using.
4.Bad Cell, replace
SOH:0%
10.60V
Rating
BAD CELL, REPLACE
Battery interior damaged, broken cell
or short circuit, replace battery.
SOH:39%
12.08V
Rating
CHARGE-RESTEST
UK - 8
SOC:30%
440A
500A
SOC:20%
0A
500A
SOC:20%
310A
500A