_CA-1000.book Seite 41 Freitag, 28. Juli 2006 10:35 10
CoolAir
5.3.2 Menu level 1: Set temperature
The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the menu
➤ Press the Mode button (see fig. 15 on page 7, 4) to change the
➤ Use the + and - buttons (see fig. 15 on page 7, 6 and 7) to select the
✓ The digits in the display flash until the parameter you enter is
➤ Press the Mode button (see fig. 15 on page 7, 4) to confirm your
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 1 and can use the + and - buttons to switch
5.3.3 Menu level 2: Switching from AC to AC/DC operation
You can upgrade the roof air conditioner with the CA-DC kit so that it can
not only be used with the vehicle stationary, but also while driving. To do
this, you must reconfigure the system software. No alterations need to be
made in this menu when you operate the system without a CA-DC
upgrade kit.
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the menu
➤ Press the + button (see fig. 15 on page 7, 6) once to switch to menu
➤ Press the Mode button (see fig. 15 on page 7, 4) to change the
✓ The digits in the display flash until the parameter you enter is
➤ Press the + and - buttons (see fig. 15 on page 7, 6 and 7) to select AC
➤ Press the Mode button (see fig. 15 on page 7, 4) to confirm your
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 2 and can use the + and - buttons to switch
mode" on page 40).
level and the second and third show the parameter which can be set.
parameter.
temperature (in °C) with which the system starts.
confirmed.
entry.
between menu levels.
mode" on page 40).
level and the second and third show the parameter which can be set.
level 2.
parameter.
confirmed.
mode (
) or AC/DC mode (
01
entry.
between menu levels.
).
02
Installation
41