Projecting - Sony VPL-VW11HT Manual De Instrucciones

Projecting

Projecting
LAMP/ TEMP/ POWER
COVER FAN SAVING STANDBY
MENU
ENTER
5,6
MUTING
PIC
INPUT SELECT
VIDEO
S VIDEO
VIDEO MEMORY
1
4
OFF
RESET
1
After all equipment is completely connected, plug
the AC power cord into the wall outlet.
The ON/STANDBY indicator lights in red and the
projector goes into the standby mode.
2
Press the I / 1 key on the control panel or
the I key on the Remote Commander.
The ON/STANDBY indicator lights in green.
3
Turn on equipment connected to the projector.
18
(GB)
5
2
ON/
4
INPUT
PATTERN LIGHT
VIDEO MEMORY
RESET
1
2
4
A B
2 3
5 6
MENU
ENTER
4
Press the INPUT key to select the input source.
INPUT-A: Selects video signal input from the INPUT
A connector, such as component
equipment.
INPUT-B: Selects video signal input from the INPUT
B connector, such as component
equipment.
VIDEO:
Selects video signal input from the VIDEO
(VIDEO IN) jack.
S-VIDEO: Selects video signal input from the S
VIDEO (VIDEO IN) jack.
5
Press the PATTERN key on the control panel to
display the test pattern, and turn the focus ring to
adjust the focus.
Press the PATTERN key again to clear the test
pattern.
6
Turn the zoom ring to adjust the size of the
picture.
Note
Looking into the lens when projecting may cause
injury to your eyes.
To Press
Cut off the picture the MUTING PIC key on the remote
commander. To restore the picture,
press the MUTING PIC key again.