Important Safety Instructions; Operating Guidelines - Motorola Solutions PMPN4563 Guia Del Usuario

Important Safety Instructions

This document contains important safety and operating instructions.
Before using the battery charger, read all the instructions and cautionary markings on the charger and
the battery.
WARNING: Read these instructions carefully and save them for future reference.
• To reduce the risk of damage to the power cord, pull the plug rather than the cord when
disconnecting power cord from the AC outlet or the charger.
• To reduce the risk of fire or electric shock, avoid using an extension cord. If an extension
cord must be used, ensure that the cord size is 18 AWG for lengths of up to 6.5 feet (2 m),
and 16 AWG for lengths up to 9.8 feet (3 m).
• To reduce the risk of fire, electric shock, or injury, do not operate the charger if it is broken or
damaged in any way. Take it to a qualified Motorola Solutions service representative.
• To reduce the risk of fire or electric shock, do not disassemble the charger. It is not
repairable and replacement parts are not available.
• To reduce the risk of electric shock, unplug the charger power adapter from the AC outlet
before attempting any maintenance or cleaning.
• To reduce the risk of injury, charge only the rechargeable authorized batteries. Other
batteries may explode, causing personal injury and damage.
• To reduce the risk of fire, electric shock, or injury, only use the accessories recommended
by Motorola Solutions.
• Changes or modifications made to this device, not expressly approved by Motorola
Solutions, could void the authority of the user to operate this equipment.

Operating Guidelines

The followings are the operating guidelines for the charger.
• This equipment is not suitable for outdoor use. Use only in dry locations and conditions.
• Maximum ambient temperature around the charger must not exceed 40 °C (104 °F).
• Recommended to turn off the radio while charging, unless the radio is transmitting data wirelessly
(through Wi-Fi).
• Connect the charger to an AC outlet using only a Motorola Solutions Authorized Power Supply.
• The AC outlet to which the power supply is connected must be nearby and easily accessible.
• Ensure that the power supply cord connected to the charger is not easily stepped on, tripped over,
or subjected to water, damage, or stress.
• Connect the power supply only to an appropriately fused and wired AC outlet with the correct
voltage, as specified on the product.
• Disconnect from the line voltage by removing the power supply from the AC outlet.
• Multi-Unit Chargers charge the batteries listed in
on page 7, when used with Pockets in
page 7. The batteries may be attached to a radio or may be stand-alone.
Table 3: Motorola Solutions non-IMPRES Batteries
Table 2: Motorola Solutions Authorized Power Cords on
MN007796A01-AB
Safety and Legal
5