Motorola Solutions PMPN4563 Guia Del Usuario página 13

Chapter 4
Mounting Multi-Unit Charger to Wall
Bracket
Procedure:
1 Position the wall mount bracket in the desired position, and mark the location of the mounting
holes on the wall surface.
CAUTION: Ensure the area behind the mounting surface is always free of electrical
wires, cables, and pipes before cutting, drilling, or installing the mounting screws.
NOTE: Mount bracket to the wall using the appropriate mounting hardware required for
the type of wall material fixture.
2 Drill based on the marked mounting holes on the wall surfaces.
3 Secure the wall bracket in position by installing mounting hardware over the mounting holes on
the wall bracket tightly.
NOTE: It is recommended to use 10-16 X 1-1/2" tapping screw and washer (not
included) on wood stud and solid flat concrete or brick wall.
4 Hang the multi-unit charger to the designated wall bracket as shown in the following images.
Table 7: Mounting Multi-Unit Charger (MUC) to Wall Bracket
1. Mount the BR000272A01 bracket onto the
wall.
3. Install the MUC.
Mounting Multi-Unit Charger to Wall Bracket
2. Install the power adapter.
1 - To MUC
2 - To power plug
4. Attach the bracket hooks into the MUC
slots.
MN007796A01-AB
1
2
13