Tabla de contenido
Publicidad
F. Setting the Power Supply
1
Ensure an approved power cord that satisfies your
regional voltage standard is used. Input voltage is
automatically detected by the system.
2
Use the mode key > to move between voltage,
amperage and time parameters.
3
To increase or decrease voltage use up (^) and down
(v) arrow keys.
To increase or decrease amperage use up and down
arrow keys.
4
Set the timer. Increase or decrease the value with
the up and down arrow keys. Between 99 hours and
59 minutes can be set as the run time. Set "0" for
Continuous.
On the left side of the Output key the flashing LED
indicates that the timer operation has been paused.
When setting up the timer in this state, set up after
having pushed the output button for a long time so as
to reset the timer.
5
Select the required output voltage up to 150 volt
or 400 mA.
6
Press the start/stop key to start the run.
•
p8
Publicidad
Tabla de contenido
