Something Not Working / Customer Service And Spare Parts; Customer Service And Spare Parts - Kuppersbusch IKEF 248-5 Istrucciones Para El Uso

Ocultar thumbs Ver también para IKEF 248-5:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
Something not Working
Problems may be due to causes which can easily be solved before calling the Technical Service. Please
follow these instructions:
SYMPTOM
Door does not close
It is too warm inside the refrigerator
It is too cold inside the refrigerator.
The compressor works continuously.
Noises
Malfunctions
If the electronics in the appliance have detected a fault that prevents the ACTUAL temperature being measured,
the temperature display
until your local Customer Service engineer has repaired the appliance.

Customer service and spare parts

If you cannot find the remedy for a malfunction in
these operating instructions, please contact your
dealer or our customer service department and
consult the Guarantee card.
Selective ordering of replacement parts can save
unnecessary travel and costs.
For this reason always provide the following
appliance information:
¥ Model Name
¥ Model Number (PNC)
¥ Serial Number (S-No.)
Weight surpasses the storage limit of the door shelf so spread weight more evenly or
take some products out.
The appliance is not properly installed. Please look in the ÒBuilding-inÓ section.
Set a lower temperature.
Distribute the food products to allow cold air to circulate around them.
Make sure that the door is completely closed and that the insulating strip is complete
and clean.
The temperature where the cabinet is placed is above normal room temperature.
Set a warmer temperature.
Set a warmer temperature.
The temperature where the cabinet is placed is above normal room temperature.
Check that the ventilation is sufficient and that the ventilation openings are
unobstructed.
The cause could be the introduction of large quantities of food and/or frequent
opening/closing of the door.
Sometimes this is normal. Temperature control may cause clicking sounds when the
system is connected or disconnected.
The injected cooling gas may produce a gurgling sound while passing through the
tubes.
The motor may cause a humming noise and/or slight bumping.
The insulation material used has a tendency to slighly increase noise levels, how ever it
allows for much better insulation and a lower energy consumption.
Your appliance is equipped with a dynamic air ventilation system. To ensure optimal
cooling performance in the refrigerator and 0¡C compartment the fan is operates with
various power levels. This results in the fan operating at different speeds for different
lengths of time. This is quite normal and not a fault with the appliance.
shows a square. The appliance will continue to function using a backup programme
SOLUTION
This information can be found on the rating plate
inside the cabenit on the left hand wall. We
recommend that you enter this information here, so
that it is handy if needed.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido