GYS ENERGY STATION Manual De Instrucciones página 14

Translation of the original instructions
USE: WARNING
In rest position, the charging clamps must ab-
solutely be placed on their support and not on
the handle which could risk electrical arcs and
short circuits resulting in a highly discharge of
the battery.
STARTER MODE
12V Mode
ou
ou
24V Mode
ou
INTERNAL BATTERIES TESTER MODE
To test the Energy Station batteries:
ou
14
ENERGY STATION
• Unplug the power supply cable or place the charging switch on « 0 ».
• Connect the cables to the battery outputs 1 or 2.
• Connect the clamp to the battery of the vehicle to start respecting the polarities.
• Go to the driver's seat and turn the ignition key. If your engine does not start, wait 3 mi-
nutes until next attempt. ( 6 sec max)
- If the cooling period between each attempt (3 minutes) is not observed or if the duration of
the attempt is too long (> 6 seconds), the chances of a successful jumpstart are significantly
reduced (risk of power loss).
- Risk of battery acid leaks or damage if the recommended periods are not observed.
- If the vehicle does not start, it may be a problem other than a faulty battery: alternator,
glowplug...
• Charge the batteries after using. (see charger mode)
• Unplug the power supply cable or place the charging switch on « 0 ».
• Connect the cables to the 24V output.
• Connect the clamps on the vehicle battery to start respecting the polarities.
• Go to the driver's seat and turn the ignition key. If your engine does not start, wait 3 mi-
nutes until next attempt. ( 6 sec max)
- If the cooling period between each attempt (3 minutes) is not observed or if the duration of
the attempt is too long (> 6 seconds), the chances of a successful jumpstart are significantly
reduced (risk of power loss).
- Risk of battery acid leaks or damage if the recommended periods are not observed.
- If the vehicle does not start, it may be a problem other than a faulty battery: alternator,
glowplug...
• Charge the batteries after using. (see charger mode)
• Unplug the power supply cable or place the charging switch on « 0 ».
• Press the key of the battery to test and the result displays:
Green light : battery charged (voltage above 12.8V).
=> starting possible.
Orange light : battery partially charged (voltage in between 12.8V and 12.4V),
=> it is highly advised to charge before using.
YES
EN
NO