GYS ENERGY STATION Manual De Instrucciones página 15

Ocultar thumbs Ver también para ENERGY STATION:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Translation of the original instructions
Red light: battery discharged (voltage below 12.4V)
=> starting impossible
No light: no battery detected or battery highly discharged (<6V)
=> starting impossible
Nb : The test is only relevant if the battery rested for at least 15 minutes.
CHARGER MODE
Charging of the Energy station internal batteries
In order for the Energy station to be always operational, and to deliver the maximum starting power, it is recom-
mended to charge the batteries after each use and to keep them on charge until the next use.
The Energy Station integrates 2 automatic chargers which charge and keep fully charge without watch the 2 internal
batteries (Floating System).
To charge the internal batteries:
• Plug the charger to the mains 230V 50/60Hz.
• Switch on « I ».
• Before starting the charge, the machine indicates the battery condition for 2 sec. :
- Red light: Battery highly discharged.
- Orange light: battery discharged but a starting is possible.
- Green light: battery is charged.
• The machine indicates the charge condition:
- Permanent orange light: charge – battery voltage increase. (12 hours max)
- Blinking orange light – voltage regulation (2h or 24 hours if the battery is sulfated)
- Green light: battery charged. Starting possible. Let the machine plugged to the mains if not
used.
• When the battery is charged, switch off « 0 »
• Unplug the the power supply cable
• Disconnect the clamps
CHARGING OF THE EXTERNAL BATTERIES.
The charger can charge 12V batteries with liquid or gel electrolyte of 35 Ah to 225Ah.
In 12V mode: to quickly charge the external batteries, it is advised the internal battery of the chosen output is fully
charged.
In 24V mode: it is imperative to have the battery fully charged.
To charge the external batteries:
• Connect the cables to the required 12V or 24V outputs (output 1 or 2).
• Connect the clamps: Red clamp on the battery "+" and black clamp on the "–"..
• Suivre la démarche de recharge des batteries internes.
ENERGY STATION
EN
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3154020026148026148

Tabla de contenido