Team kalorik TKG SIS 1000 Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Fax +32 2 359 95 50
The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,
wrinkle, relief etc.), the textile can best be ironed at a lower temperature.
First sort out the fabrics according to ironing temperature: wool with wool, cotton with
cotton, etc.
The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring
the lowest temperature such as those made of synthetic fibres. Then progress to the higher
temperatures.
If the article is made of a mixture of different fibres, you must always select the lowest
ironing temperature of the composition of those fibres.
(E.g. an article consisting of "60% polyester and 40% cotton" should be ironed at the
temperature indicated for polyester and without steam.)
If you do not know what kind(s) of fabric(s) the article has been made of, find a spot
which will be invisible when wearing or using the article to try out the ironing temperature.
(Always start at a low temperature and increase to one which gives the required results.)
Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is
recommended to set the selector switch on position "Cotton", apply shot-of-steam and
use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be
prevented by turning the article inside out and ironing the inside or by interposing a light
damp cloth.
Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this
may cause stains.
When you have been ironing fabrics at a high setting, do not iron articles that require a
lower temperature (such as nylon...) immediately afterwards. Adjust the selector switch to
a lower setting and wait a few minutes until the blue indicator lamp of the chosen setting
stops blinking rapidly and lights up steadily. A beep will sound as well, indicating that you
can start ironing again.
FILLING WITH WATER (FOR STEAM-IRONING)
1.
Put the base on a stable surface.
2.
Press the release button (12) situated at the bottom of the water
tank and slide the water tank out of the base (Fig. 1).
3.
Lift the anti-calc cartridge out of the filling funnel (Fig. 2).
4.
Fill the water tank with clear water up to its "Max" level (Fig. 3). Do
not fill beyond this maximum level! You can use tap water, but we
advise you to use distilled water.
5.
Put the anti-calc cartridge back in place (Fig. 4).
6.
Put the water tank back in the base correctly. Slide it backward
until it is locked (Fig. 5).
7.
Never use vinegar, detergents or other chemical products.
8.
Pour out the remaining water after use (Fig. 6).
Caution: always make sure that the anti-scale cartridge is well in place.
Never use the appliance without anti-scale cartridge.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
14
Assembly page 14/72
TKG SIS 1000 - 081224

Publicidad

Tabla de contenido
loading

Tabla de contenido