Steam-Ironing; Dry Ironing; Automatic Shut-Off - Team kalorik TKG SIS 1000 Manual De Instrucciones

Fax +32 2 359 95 50
FILLING THE WATER TANK DURING USE
As the water tank of this appliance is not under pressure, you can refill it during use. To do so,
just proceed as described above in the "Filling with water" section.

STEAM-IRONING

• Fill the water tank with water and insert the mains plug into a wall socket. Hint: for a better
performance, immerse the anti-calc cartridge in water for a few minutes before installing it
into the water tank.
•
When you plug in the appliance, the red power light
on permanently, indicating that the appliance is connected to the mains.
• Press the selector switch to choose the desired setting
(POLYESTER/RAYON/COTTON/LINEN). The blue indicator light of the chosen setting will
blink, indicating that the iron is heating. When the iron has reached the desired
temperature, the blue indicator light will light up steadily and a beep will sound. You can
now use the steam function.
• Press the steam button (6) to release steam from the soleplate of the iron. Release the
button and the steam will stop. If you want a continuous jet of steam, hold the steam
button down. For the POLYESTER/RAYON/COTTON/LINEN settings, the steam rate will vary
automatically according to the temperature of the sole-plate in order to prevent water
dripping from the sole-plate. The pump will stop working and no steam will escape when
the temperature of the sole-plate has decreased too much; it will start working again
when the sole-plate has been reheated to the desired temperature. (Note: the steam
function is not available for the NYLON setting.)
•
When ironing, the blue indicator light of the chosen setting will start blinking again from
time to time. This means that the temperature of the iron is regulated by its thermostat. You
can continue ironing.
• When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there isn't enough water in the water tank.
• When the water tank is running empty, you will hear a sound signal. If you want to go on
using the steam function, you will have to refill the water tank.
Note: when you start using the steam function, it is normal that the electrical pump makes
some vibrating sounds. This is due to the air inside the anti-calc cartridge and will lessen when
the air has been pumped out. If the noise has not diminished after 60 seconds, check if the
water tank and the cartridge have been assembled correctly.
STEAMING IN A VERTICAL POSITION
You have to hang the cloth you want to smooth out avoiding creases and place the iron in a
vertical position at a few centimetres (5 - 15 cm) from the piece of cloth. Then move the iron
and press the burst of steam button at the same time.

DRY IRONING

For ironing without steam, do not press the steam button (6).

AUTOMATIC SHUT-OFF

The appliance will shut off automatically when it has been used continuously for 60 minutes
and a beep will sound. The power light
Press the selector switch if you want to restart the appliance.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
of the display will light up. It stays
will blink.
15
Assembly page 15/72
TKG SIS 1000 - 081224