Daikin EWYQ F Serie Manual De Instalación, Operación Y Mantenimiento página 11

If the unit is correctly installed, operated and manteined the
noise emission level do not require any special protection
device to operate continuosly close to the unit without any risk.
In case of installation with special noise requirements it could
be necessary to install additional sound attenuation devices.
Moving and lifting
Avoid bumping and/or jolting during loading/unloading unit
from the truck and moving it. Do not push or pull the unit from
any part other than the base frame. Secure the unit inside the
truck to prevent it from moving and causing damages. Do not
allow any part of the unit to fall during transportation or
loading/unloading.
7 : RIGGING INSTRUCTION
Figure 3 - Lifting the unit
EWYQ160F ~ EWYQ230F
All units are supplied with the lifting points marked in yellow.
Only these points may be used for lifting the unit, as shown in
the following figure.
Both the lifting ropes and the spacing bars must be
strong enough to support the unit safely. Please check
the unit's weight on the unit nameplate.
The unit must be lifted with the utmost attention and care
following lifting label instructions; lift unit very slowly, keeping it
perfectly level. Follow the rigging instruction described en the
label attached on the electrical panel of the unit.
D-EIMHP00604-14EU - 11/208