Kärcher BD 700 BAT Instrucciones De Manejo página 26

BD 700 BAT / BR 700 BAT
Preparing for Unit
Start-up
40
39
26
Mounting the disc brushes or brush drums
For BD 700 BAT
The disc brushes (29) have not been mounted onto the brush head prior
to delivery.
To mount the brushes – see chapter "Care and Maintenance".
For the different types of disc brush – see chapter "Accessories".
For BR 700 BAT
The brush drums have already been mounted prior to delivery.
To replace brush drums – see chapter "Care and Maintenance".
For the different types of brush drum – see chapter "Accessories".
Information applying to BR 700 BAT
The effective cleaning width can be increased up to 900 mm by
extending the brush drums. This is achieved by pressing the "Extend
brush drums" switch until the required width is attained. The brush
drums are retracted by pressing switch (40).
Mounting the suction bar
– Fit the suction bar (5) into its holder, and tighten knobs (32). Push
suction hose (36) onto connector (8) on the suction bar.
Selecting the most suitable brushes (29) for the cleaning task
The chapter "Accessories" contains information about the various
scrubbing brushes, pad discs and cleaning pads, together with application
details that enable the correct selection of the most suitable tool for any
particular cleaning task.
Adding the detergent solution
– A plastic bag for fresh water (3) is hung inside the dirty-water tank (2).
Use a hose to fill this bag.
Note: Add detergent corresponding
application (see section "Recommended Cleaning Agents".
– Fill the plastic bag (3) up to a maximum of one handbreadth below the
lip of the tank opening.
– Check that the submerged pump (31) is hanging in the plastic bag.
Tank cover (30) must be closed before the unit is started up.
– An appropriate amount of foam-retarding agents can be added.
English
to the intended cleaning