Tabla de contenido
Publicidad
Installation and Operation Manual
X-VAP-VDM100-eng
Part Number: 541B178AAG
December, 2012
2.1 General
2.2 Receipt of Equipment
Brooks
This section contains the procedures for the receipt and installation of the
instrument. Do not attempt to start the system until the instrument has
been permanently installed. It is extremely important that the start-up
procedures be followed in the exact sequence presented.
When the instrument is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should be notified at once regarding his liability.
A report should be submitted to your nearest Product Service Department.
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554 FLOW (3569)
Tel (215) 362 3700
Fax (215) 362 3745
E-mail: BrooksAm@BrooksInstrument.com
www.BrooksInstrument.com
Brooks Instrument
Neonstraat 3
6718 WX Ede, Netherlands
P.O. Box 428
6710 BK Ede, Netherlands
Tel +31 (0) 318 549 300
Fax +31 (0) 318 549 309
E-mail: BrooksEu@BrooksInstrument.com
Remove the envelope containing the packing list. Unpack and inspect the
VDM100 and additional items for any possible shipping damage. The
VDM100 is shipped with two replacement fuses for the power entry
module. A piece of 1/8" O.D. Teflon tubing also comes with the VDM100.
This tubing can be connected to the Tank Drain when draining Dl water
from the tank inside the VDM100. Contact Brooks if there are any
problems or if more information is required.
The following items can be purchased separately; these items are not
necessary for the installation and normal operation of the VDM100:
The Brooks GUI provides diagnostic tools and an alternate access to
VDM100 functions.
A serial communication package that is utilized by the Brooks GUI provides
means to connect between a PC or laptop (where the GUI is installed), and
the VDM100 RS485 Diagnostic Port. This package consists of an RS232
to RS485 converter that plugs into the serial communications port of the
computer and a cable that connects the converter to the 2.5 mm Mini Jack
on the VDM100.
NOTE: The Brooks GUI must be installed on a computer in order to
perform any diagnostic function. Contact Brooks for information on
purchasing the GUI software and serial communication cabling. Refer to
the Brooks Software User manual for the installation and operation of the
Brooks GUl.
Section 2 Installation
®
VDM100 Vapor Delivery Module
Brooks Instrument
1-4-4 Kitasuna Koto-Ku
Tokyo, 136-0073 Japan
Tel +81 (0) 3 5633 7100
Fax +81 (0) 3 5633 7101
Email: BrooksAs@BrooksInstrument.com
2-1
Publicidad
Tabla de contenido
