Honeywell HM500 Serie Manual Del Usuario página 11

Removing the half mask
Release the buckle behind the neck, and then take off the half mask.
For HM502, once the buckle is released tilt gently the nose cup upwards while pulling the half
mask down to allow for smooth sliding without needing to take the head harness off.
Do not remove the mask before leaving the contaminated area. When removing the mask,
take all necessary precautions to avoid inhaling the dust or contaminant retained on the
external surface of the mask.
Cleaning and disinfection
1) Unscrew the filters from the connectors.
2) Wash the half mask with lukewarm soap water or in an ultrasound tub with EPI U-S 19a (P/N
1779065) in 3% watery solution. Do not use organic solvents or abrasive products for the cleaning.
3) Rinse the half mask thoroughly under clean running water.
4) Dry the half mask with a clean lint-free cloth and hang up neck strap in a well-ventilated area
away from sunlight.
5) Screw on the new filters after cleaning the half mask.
MAINTENANCE ______________________________________________________________________________
Perform a monthly inspection of the half mask to detect deteriorations, torn straps and face blank,
split seals and valves. Change the part immediately if any damage detected. Never use the half
mask until worn or damaged parts have been replaced. Follow the recommended maintenance
schedule. The date of manufacture is the means to identify half mask.
Cleaning, disinfection
Change of valves and gasket
List of spare parts
Part number
N06577018
HM5RP02
HM5RP03
HM5RP03D
HM5RP04B
WARRANTY __________________________________________________________________________________
Honeywell Respiratory Safety Products warrants this half mask to the original owner to be free
from defects in materials and workmanship for one year from the date of original shipment from
Honeywell's factory. Honeywell's obligation under this warranty will be, at Honeywell's option,
to repair or replace without charge the half mask or any of its components found by Honeywell
to have been defective during the warranty period, under the following terms:
• The warranty claim is made (i) by the owner who purchased the HM500 Series half mask new from
Honeywell or an authorized Honeywell Distributor, and (ii) not more than three (3) months after
the end of the warranty period.
• The HM500 Series half mask or component is found by Honeywell to have been defective in normal
use and service during the warranty period of one (1) year from the date of purchase by the owner.
IMPORTANT
Regular maintenance schedule
Exhalation Valve (770018)
Inhalation Valve
Head Harness Assembly (for HM501)
Head Harness Assembly (for HM502)
Bayonet Gasket
EN-3
After each use
Every second year
Description