Maxi-Cosi Emerald i-Size Instrucciones De Uso página 67

Your child in the Emerald car seat
• The newborn inlay included in your Emerald
seat plays an integral part in the efficiency of
the restraint system for your child from 40 to 75
cm. It can be removed and the cover taken off for
washing, but it is essential to place it back again
where it belongs and only use this official Maxi-
Cosi Emerald newborn inlay. This newborn inlay
is exclusively for use with the Emerald seat.
• It is mandatory to use the newborn inlay when
your child's length is from 40 to 75 cm.
• Always make sure to remove the inlay when
your child's length is more than 75 cm.
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm).
If there is more space than 1 cm, tighten the
harness belt further.
• Make sure the headrest is adjusted to the
proper height.
ATTENTION:
• In ISOFIX use, the fitting clips for lower
anchorage to the vehicle are not sufficient. It is
essential to fix the "Support Leg" .
• The ISOFIX anchors have been developed
to obtain a safe and easy fixation of the child
safety systems inside the car. Not all cars are
equipped with these anchors although they are
standard on more recent models.
CARE
The cover, headrest cover, shoulder pads, crotch
pad and the newborn inlay can be removed for
washing. If the cover needs to be replaced at any
time, only use official Maxi-Cosi covers because
it constitutes an integral part of the restraint
performance.
EN
I I
Maxi-Cosi Emerald 67