Changing The Gas Supply - De Dietrich DTI 1127 X Manual De Instrucciones

2 2 / / INSTALLING YOUR APPLIANCE
EN

CHANGING THE GAS SUPPLY

•
Note
The default settings on your hob are
for natural gas.
The injectors required for adapting the hob
to a butane/propane supply can be found in
the same plastic pocket as this guide.
Each time you change the gas supply, you
must complete the following steps:
— Adapt the gas connection
— Change the injectors
— Connect the hob to the electrical supply
— Check the type of gas supplied
•
Adapt the gas connector on the hob to the
new gas setting. Refer to the "Connecting to
the gas supply" section.
•
Change the injectors proceeding as
follows:
— Remove the pan supports, heads and
covers from all burners (Fig. 01) .
— Using the tool provided, unscrew and
remove the injectors located under each
crucible (Fig. 02).
— Replace with the new gas injectors; refer to
the injector positioning markers and the gas
settings table at the end of this chapter. The
new injectors should be fitted as follows:
— First, manually tighten as far as possible.
— Then fully engage the key onto the injector.
— Draw a line on the burner plate using a
pencil, as shown (Fig. 03).
— Turn the wrench clockwise until the line
appears on the opposite side of the key
(Fig. 04).
Note
Exceeding this limit may damage the
product.
— Replace the burner heads, burner covers
and pan supports on the hob.
Tip
Each time you change the gas supply,
tick the box corresponding to the new gas
level on the label found in the plastic bag.
See "Connecting to gas the supply" .
Fig. 01
Fig. 02
Fig. 03
Fig. 04
50
Grid
Burner cover
Head
Thermocouple
Spark igniter
Wrench
Crucible
Injector
Line
Wrench
Line
Wrench