Electrical Connection - De Dietrich DTI 1127 X Manual De Instrucciones

2 2 / / INSTALLING YOUR APPLIANCE
•

ELECTRICAL CONNECTION

Your hob must be connected to a
220-240 V ~ single phase mains supply via a
standard IEC 60083 2 pole + earth electrical
plug or an all-pole isolator, in compliance
with the current installation regulations.
The electrical plug must remain accessible
after installation.
— Connect the wires to the electricity supply,
taking note of the colour of each wire (see
diagram opposite).
When power is first supplied to your hob, or
after an extended power cut, an indicator
light will be displayed on the control panel.
This information will disappear after
20 seconds.
— The safety wire (green and yellow) is connected to the appliance's earth
terminal
— If the power cable is damaged, it must be replaced by the manufacturer, the After-
Sales Service or a similarly qualified person, to avoid any risk.
and must be connected to the mains earth terminal
C
ROSS-SECTION OF CABLE TO BE USED
220-240 V ~ - 50 Hz
H05V2V2F - T90
Cross-section of
conductors in mm²
Fuse
Blue wire
Green and
yellow wire
47
Model Model
DTG1127* DTI1127*
220-240 V ~ - 50 Hz
3 conductors
including
1 for earth
1
10A
Black, brown
or red wire
Neutral
.
EN
1.5
16A
(N)
Phase
(L)
Earth