Flex LDC 1709 FR Manual Del Usuario página 20

 Screw the clamping nut (B), with flange face
up, onto the spindle.
 Press and hold down the spindle lock.
 Tighten the clamping nut with the stop key.
 LDC 1709 FR/LDC 1509 FR:
Check position of the guard:
The brush ring should protrude over the
sanding pad by approx. 0–1 mm. If required,
correct (see "Adjusting the guard
(LDC 1709 FR/LDC 1509 FR)").
 Insert the mains plug into the socket.
 Switch on the electric power tool (without
locking the button) and leave it running for
approx. 30 seconds. Check for imbalances
and vibrations.
 Switch off the electric power tool.
20
LDC 1709 FR/LD 1709 FR/LDC 1509 FR
Switching the electric power tool
on and off
Brief operation without engaged switch
rocker:
 Push the switch rocker forwards and hold
in position.
 To switch off the power tool, release the
switch rocker.
Continuous operation with engaged switch
rocker:
`^rqflk>
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇ=çå=
ÉäÉÅíêáÅ=éçïÉê=íççä=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 Push the switch rocker forwards and
engage by pressing the front end.