Start-Up; Providing The Mains Cable And Checking The Mains Connection; Carrying Out Visual Inspection; Operation - AL-KO COMBI-CARE 36 E comfort Traducción Del Manual Original De Instrucciones

Start-up

5 START-UP
5.1 Providing the mains cable and checking
the mains connection
Heed the safety instructions for the mains cable
(see chapter 3.6 "Electrical safety", page 22).
Requirements for the mains cable
Provide a mains cable that complies with the fol-
lowing requirements:
■
3 conductors with a minimum cross-section
of 2.5 mm (i.e. with protective conductor)
■
Maximum length of 40 m
■
Spray water protected (protection category
IP44)
■
Suitable for outdoor use (H05RN-F quality,
i.e. rubber hose cable)
Requirements for the mains connection
Check that the mains connection complies with
the following requirements:
■
Min. 10 A fuse
■
Fault current circuit breaker with max. 30 mA
trigger current
5.2

Carrying out visual inspection

1. Check the appliance for damage and loose
screws. Replace the defective appliance
parts and tighten the screws.
2. Check the mains cable for damage. Replace
the defective mains cable.
3. Check the appliance for coarse soiling. Re-
move soiling.

6 OPERATION

NOTE
Always mow the grass before scarifying
(max. grass height: 4 cm).
Remove any foreign bodies from the
grass surface.
441970_b
6.1

Folding the handlebar in and out (05)

CAUTION!
Danger of crushing
Fingers or other parts of
the body can be crushed
between the loose parts of
the handlebar.
■
Hold the loose parts of
the handlebar tightly.
■
Do not hold any fingers
or other parts of the
body between the loose
parts.
IMPORTANT!
Danger of damaging the
power cable
The motor and mains
cables can be crushed and
damaged between the
loose parts of the handle-
bar.
■
Do not jam the cables
when folding the
handlebar in/out.
Folding in the handlebar
1. Release the quick release on the rotary/snap-
in joints (05/1) until the entire handlebar
(05/2) can be folded forward into the hori-
zontal position (pos. a).
2. Release the bottom quick release (05/3) and
fold the top handlebar incl. middle part (05/4)
to the rear (pos. b).
3. Release the top quick release (05/5) and fold
the handlebar (05/6) forward into the hori-
zontal position (pos. c).
4. Slightly tighten all quick releases.
23