KBT seesaw Modo De Empleo página 3

13 17
9 11
9
13 13
17 17
18
ASSEMBLY - MONTAGE - MONTAJE - MONTAGGIO - MONTAŻ
13 17
11
INSTALLATION
To be conform with the standards EN 1176-1:2008 and EN 1176-6:2008, the product needs to be assembled res-
pecting the correct dimensions and distances as shown below in the drawing and the table.
ASSEMBLY LOCATION OF THE DIFFERENT PARTS
(1) hinge: center of beam
(2) hand grip/seat: close to each other
(3) softener : end of beam
max. 20°
Check after the installation that the lateral deviation, measured at a distance
of 2000 mm from the axis point, does not exceed 140 mm.
90 - 120 mm Ø 140 - 180 mm
distance bottom beam-ground level
500 mm
600 mm
# 261.020.010.001
700 mm
# 261.020.020.001
Table: Resulting angle and height for a few possible setups.
center of the seat
height: max. 1500 mm
when level
(1)
height of the seat: max. 1000 mm
2000
max. 140
beam lenght 3 m 4 m
dimensions beam (mm) fall height (mm) - max. 1500
resulting angle 14° 10°
90 955 -
100 965 962
120 984 981
140 1004 1001
180 1043 1040
resulting angle 18° 13,5°
90 1159 1155
100 1168 1164
120 1187 1184
140 1206 1203
180 1244 1242
resulting angle x 17°
90 x 1357
100 x 1367
120 x 1386
140 x 1405
180 x 1443
x = not in accordance with EN 1176-6
seesaw
Instructions for use - M26x.02 - seesaw
(2)
(3)
5 m
8°
-
-
979
999
1039
11°
1152
1162
1182
1201
1241
13°
1354
1364
1384
1403
1442
3