Kit Assembly - Metra 99-6519 Instrucciones De Instalación

Ocultar thumbs Ver también para 99-6519:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ISO DIN radio provision with pocket
1. Attach the radio brackets to the radio
housing by sliding the grooves in the
brackets, into the housing. The following
step will secure the brackets in place.
(Figure A)
2. Attach the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio.
(Figure C)

KIT ASSEMBLY

(Figure A)
(Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Secure the radio assembly to the dash
using the factory screws.
7. Attach the (6) panel clips provided
to the 99-6519B radio housing trim
panel, then reassemble the dash in
reverse order of disassembly using the
99-6519B radio housing trim panel to
complete the installation.
(Figure C)
REV. 2/27/2018 INST99-6519
3

Publicidad

Tabla de contenido
loading

Tabla de contenido