3
Wood Stud Mounting continued
[02]
[07]
8
[02]
Level the wall plate [02] and mark the
locations.
Drill pilot holes as illustrated.
CAUTION:
Pilot holes MUST be
drilled to a depth of 75 mm (3 in.), using a
5.5 mm (7⁄32 in.) diameter drill bit.
Place the wall plate [02] against the wall. Tighten lag bolts
[07] only until they are pulled fi rmly against the wall plate
[02].
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or property
damage:
DO NOT over-tighten the lag bolts [07].
13mm
5.5mm
(1/2 in.)
(7/32 in.)
75 mm
3 in.
6901-002064 <01>