4
Wall Mounting - Solid Concrete
and Concrete Block
[02]
[02]
[07]
6901-002064 <01>
Level wall plate [02] and mark the hole locations.
Mount wall plate [02] directly onto the concrete
surface.
Minimum solid concrete thickness: 8 in.
CAUTION:
Pilot holes MUST be drilled to a depth of
75 mm (3 in.), using a 10 mm (3⁄8 in.) diameter drill bit.
75 mm
(3 in.)
CAUTION:
To avoid potential injuries or property
damage be sure the anchors [08] seat fl ush with the
concrete surface.
[08]
Place the wall plate [02] against the wall. Tighten lag bolts
[07] only until they are pulled fi rmly against the wall plate
[02].
CAUTION:
Improper use could reduce the holding
power of the lag bolt. To avoid potential injuries or property
damage:
DO NOT over-tighten the lag bolts [07].
13mm
10 mm
(1/2 in.)
(3/8 in.)
9