Electrolux ENA34835W Manual De Instrucciones página 9

4. Unscrew the valve in counter clockwise (pay
particular attention not to lose the Valve Gas-
ket because is necessary to a correct func-
tioning of the features ).
5. Clean the tank lid, the valve and the gasket
with a solution of warm water and neutral
soap. Rinse it and put it inside the door hole
during the cleaning of the other components
(in order to avoid cold air leakage from the
fridge).
6. Clean the tank and the funnel into the dish-
washer or with a solution of warm water and
neutral soap and rinse them.
7. After the tank components cleaning take back
the valve from the fridge door and assembly
the tank in the inverse order (4;3;2;1) of dis-
assembly (pay attention at the valve gasket
positioning ).
8. Put the assembled tank on the door along the
valve direction.
9. Block the stopping elements in the inverse or-
der of unblock.
10. Insert again the BRITA MAXTRA cartridge in
the funnel .
How to use the BRITA MAXTRA filter
cartridge
Step 1: Preparing the cartridge
To prepare your BRITA filter cartridge, please re-
move the protective wrapper (note: cartridge and
inside wrapper may appear moist, this is simply
condensation).
Immerse the cartridge in cold water and shake it
gently to remove any air bubbles. The filter now is
ready to use.
As required for some other water filter cartridges,
there is no need to pre-soak the new Maxtra Car-
tridge.
Step 2: Insert in the water tank
Remove the tank lid. Before inserting the cartridge,
remove the funnel and clean it thoroughly by rising
it and wiping it dry.
Then, thoroughly clean the inside of the water tank
with a dump cloth and wipe it dry as well.
Place the cartridge into the filter tank and push
downwards until it 'clicks' firmly into place.
The cartridge should stay in place if the funnel is
turned upside down.
Step 3: Rinse the cartridge
2x
Take the funnel out of the BRITA water filter unit,
fill it under the tap with cold tap water and allow it
to filter through.
electrolux 9
3x=ok