YATO YT-73124 Manual De Instrucciones página 15

measurement for the longer side. The result of the measurements
of distance will be displayed in the field of results of the previous
measurements, and the calculated surface area will be displayed in
the field of the result of the last measurement.
Measurements of cubic capacity
ATTENTION! It is possible to realise measurements of cubic capac-
ity of a single cuboid at a time. Measurements of cubic capacity
of bodies of another form must be divided into cuboids, and then
realise measurements of each of them separately and sum up the
results of the measurements.
Activate the appliance and select the adequate measurement basis.
Press the menu button, until the indicator of measurements of cu-
bic capacity is displayed with a blinking edge of the cuboid. Press
the measurement button to activate the laser indicator. Press the
measurement button in order to measure all the edges successively.
Measurements of distance will be displayed in the field of results of
the previous measurements, and the calculated cubic capacity will
be displayed in the field of the result of the last measurement.
Measurements with a right-angled triangle
Those measurements are realised when it is not possible to carry out
direct measurements, for example when there are obstacles along
the route of the laser beam. Activate the appliance and select the
adequate measurement basis. Press the menu button, until the in-
dicator of measurements with right-angled triangle is displayed. The
symbol of the measurement will be displayed with a blinking edge.
Carry out the measurement as in case of single measurements, and
then measure the other distance. Measurements of distance will be
displayed in the field of results of the previous measurements, and
the distance measured by means of the Pythagorean theorem will
be displayed in the field of the result of the last measurement.
ATTENTION! The first measured distance must exceed the second
one. Otherwise, the result of the measurement will be erroneous. It
is required to realise the measurements of single distance with the
highest possible exactitude, which will imply only slight errors of the
result of the direct measurements.
Measurements with a double right-angled triangle
Those measurements are realised when it is not possible to carry
out direct measurements, and the beginning and the end of the dis-
tance is below the measurement point.
ATTENTION! The most precise results of measurements are ob-
tained when the measurement point is in the middle of the meas-
ured distance. Any other position of measurement point will imply
en error of measurement.
Activate the appliance and select the adequate measurement ba-
sis. Press the menu button, until the indicator of measurements
with a double right-angled triangle is displayed. The symbol of the
measurement will be displayed with a blinking edge. Carry out the
measurements as in the case of single measurements, and then
measure the other distance. The measurements of distance will be
displayed in the field of results of the previous measurements, and
the distance measured by means of the Pythagorean theorem will
be displayed in the field of the result of the last measurement.
ATTENTION! The first and the third measured distances must ex-
ceed the second one. . Otherwise, the result of the measurement will
be erroneous. It is required to realise the measurements of single
distances with the highest possible exactitude, which will imply only
slight errors of the result of the direct measurements.
15