Ccessories; Installation; Ssembling The Ccessories; Ontrols And Onnection To The Ains Ater Upply - BM2 BIEMMEDUE M130 Manual Del Usuario

• Rotating water jet brush: designed for cleaning delicate surfaces.
• floor cleaning lance.
m
WARNING
• The operation of the water cleaner may be impaired if unsuitable accessories are used and they
may even make it dangerous. Only use original accessories endorsed by the Manufacturer.
Refer to the documents provided with the optional accessories for information regarding their
general use, safety warnings, installation and maintenance.
4 I
nstallatIon
4.1 a
ssemblInG the
a) Insert the handling bar (3) onto the body of the high pressure cleaner. Make sure you fully
insert the bar into the high-pressure cleaner's body (the front surfaces must be aligned with
one another). Secure the bar with the 2 screws supplied (cross head screwdriver not supplied).
Operation A in Fig. 2.
b) The high-pressure water cleaner is supplied with a lance hose (28) which can be fitted with a
standard nozzle support head (27), or a head with a swivel nozzle (18), using a bayonet mount.
Depending on the job to be done, fit one of the two heads by inserting it into the lance hose
and turning it clockwise until it clicks securely onto the coupling. Now block it in place with
the Securfix ring nut (11), by turning it clockwise. Step I in Fig. 2.
To remove the head, turn the Securfix ring nut (11) anti-clockwise and remove it. Keep the
head pressed down into the lance hose housing and turn it anticlockwise until it is released,
then remove it completely. Step H in Fig. 2.
c) Unroll the high-pressure hose (23), connect the quick-fit connector (24) to the water outlet
connector (8), screw down and secure. Operation C in Fig. 3.
d) Screw the end of the high pressure hose (23) (the end without the quick fit connector) onto the
thread of the spray gun (14) and secure it tightly using two 17 mm socket keys (not supplied).
Operation D in Fig. 3.
4.2 C
ontrols anD
CAUTION
• The water supply must be able to guarantee the adequate delivery of water flow to the high
pressure cleaner; refer to the table of technical specifications.
In case of doubt, contact a Skilled Technician.
• Do not supply the water cleaner with water at a temperature in excess of 40°C /98°F or below
5°C/41°F.
• The pressure of the water supply must not be in excess of 8 bar/116 psi.
• Do not operate the high pressure cleaner with a priming depth in excess of 0 m/0 ft.
• Do not operate the high pressure cleaner if it is not connected to a water supply.
• Do not supply the high pressure cleaner with salt water or water containing impurities. In this
event, run the high pressure cleaner for a few minutes with clean water.
m
WARNING
• Follow current regulations for connection to the mains water supply in the country where the
water cleaner is installed.
a

CCessorIes

C
onneCtIon to the
m W s
aIns ater upply
29