Edge Banding Mobile Use; Edge Banding Stationary Use - HOLZMANN MASCHINEN KAM 45PRO Instrucciones De Servicio

13.3.5 Edge banding mobile use

 If motor is not turning on (glue has not fully dissolved), when digital panel showing (Er2),
increase the heating temperature and switch on motor again when reached up re-set
temperature.
 Feeding rollers must always be clean.
 Cut the edge banding material to the required length + 5% or 10cm.
 Before the edge banding operation, make sure the glue is completely melted into liquid
(Using the tool and glove while opening the glue pot to check).
 Place the guide plate onto the work piece and place the pressure roller close to the work
piece without touching it.
 Hold the machine tightly by both hands while handling (2) and (3). Press switch (1), and
the feed starts.
 Place the edge banding material into the feeding entrance until the edge band touches roller
(4). The edge band will be transported automatically.
 As soon as the edge banding material has reached the pressure roller, press the pressure
roller against the workpiece. The movement of the pressure roller automatically moves the
machine ahead.
NOTE: Once the edge banding material is applied to the workpiece, apply constant pressure
to achieve even edge banding.
 The machine is automatically moved forward by the feed of the pressure roller.
 The feeding speed can be adjusted variably with the speed regulator (1) on the handle (2).
 At the end of the edge band make sure that the machine is led further uniformly in height
and direction until the protruding edge band is led out of the pressure roller.
 Remove protruding edge banding material with edge trimmer and edge cutter (optional).

13.3.6 Edge banding stationary use

HOLZMANN MASCHINEN GmbH
 Switch on main switch
 Switch on heating.
 Adjust temperature setting to the used glue granule. To
switch Mode1/Mode2 press
When temperature reaches up to 120°C (250°F),
operating light
switch may accelerate heating process.
 It takes app. 20 ~ 30 minutes before the glue is
completely melted.
 Use the assembly fixture, prepare an artificial
 Use included screws to install the assembly fixture.
www.holzmann-maschinen.at
will light up, switching on the feeding
board 20mm thick for using formwork to trace
out the cutting shape.
OPERATION
together for. 3 sec.
KAM45PRO
29