3.5 Place the Safety Pod
Wipe the surface of the Safety
Pod's suction cup with the provided
Finishing Cloth.
If WINBOT 9 is being used to clean an
inside window: Press the Safety Pod
FIRMLY on the top corner of the inside
window. Make sure the Safety Pod is
attached securely in place.
If WINBOT 9 is being used to clean an
outside window: Press the Safety Pod
FIRMLY on the inside of the window
being cleaned. Make sure the Safety
Pod is attached securely in place.
3.6 Spray Cleaning Solution
WINBOT 9 is recommended to be used with WINBOT Cleaning Solution. Using other
*
cleaners may reduce WINBOT's performance.
Spray each side of the Cleaning Pad with the
provided WINBOT Cleaning Solution 3 times.
The Cleaning Pad should be damp, not wet.
3. Operating the Robot
After spraying, wipe the bottom of WINBOT 9
with the provided Finishing Cloth.
9
EN