Maintenance; Cleaning Pad; Cupule, Sensors, Squeegee, Corners - ECOVACS WINBOT 9 Manual De Instrucciones

Before performing cleaning and maintenance on WINBOT 9, move the Bottom Power Switch
O
to the " " position and unplug it from the receptacle.

4.1 Cleaning Pad

Turn the robot over and remove the Cleaning
Pad. Soak the Cleaning Pad in cool, clean
water for 2 minutes. Hand wash with mild
detergent and lay flat to dry. Allow the Cleaning
Pad to dry completely before re-attaching it
to the robot.
Do NOT use a wet Cleaning Pad on
*
WINBOT 9, or it may slip on the window.
Washing the Cleaning Pad regularly
*
can extend its service life.
If the Cleaning Pad becomes worn or
*
no longer fits exactly within its Velcro
area, replace it with a new one to
achieve best cleaning performance.

4.2 Cupule, Sensors, Squeegee, Corners

Cupule
Turn the robot over and wipe any debris from
the surface of the Cupule with the provided
Finishing Cloth to maintain suction.

4. Maintenance

Wheel Sensor
Turn the robot over and wipe the Wheel
Sensor with the provided Finishing Cloth
to maintain its effectiveness.
13
EN