EHEIM 2227 Manual Del Usuario página 20

EHEIM professionel wet/dry canister filter 2227 and 2229
EHEIM professionel wet/dry thermofilter 2327 and 2329
Pump head Sealing gasket
screen Media containers
Wet/dry floater compartment
floating control valve
tap connector Hose clamp
bar and end cap Intake pipe
prefilter Intake/outtake for breather tube
k
tion cups with clips
22
k Cleaning brush Thermofilter:
24
ture sensor k Velcro tape
27
Attention: 2327 and 2329 thermofilters should only be
used for freshwater.
When unpacking, please check to make sure that all parts
have been included.
Assembly
Attention: In order to guarantee the synchronized function-
ing of the wet/dry filter, use only the enclosed original parts.
Changes should not be made in the intake or output areas.
Flip out all four EZ clips and push upwards. With the help of
the two recessed lid handles, the pump head of the filter can
be easily removed.
Take out the lattice
screen as well as the
individual media con-
tainers one at a time.
The retractable hand-
les of the media con-
tainers can be pulled
out in an upward di-
rection.
Output pipe
EZ clips Filter canister
Sealing ring
Locking pins Integrated double
Security outlet pipe
Intake strainer
Tubing
k
Key for locking pins
23
k Thermostat k
25 26
Now fill the media containers to just below the edge, ONLY
with original SUBSTRATpro or EHFISUBSTRAT filter media.
Lattice
Attention: Do not overfill. Do not clog flow-through
pipe. In all media containers only use SUBSTRATpro
Wet/dry
or EHFISUBSTRAT.
Spray
Then, thoroughly rinse filter media under running water un-
Foam
til all cloudiness has disappeared.
k Suc-
21
Vaseline
Tempera-
After you have checked to be sure that the wet/dry connec-
tion supports are not soiled, put the first media container
back into the filter canister. When doing so, be sure that the
flow-through opening sits above the wet/dry connection
supports. Firmly press the media container downwards until
it rests on the support frames. This guarantees a secure seal
between media container and filter canister.
Push in the second (and third) media container in the same
manner, so that the pipe openings lie on top of each other.
Again lower the retractable handles for each of them and
be sure that all of the media containers lie flush on top of
each other. Place lattice screen.
16