Installation
12
5.2 Electrical connection
Danger: Only a qualified electrician is
allowed to work on the electrical connection.
Before establishing the connection, make sure
that the connecting cable is dead.
•
Establish the electrical connection as follows:
Fig. 3a to 3e
•
Open the WILO- Connector as follows:
Fig. 2
5.3 Filling and venting
1. Fill the system.
2. The pump rotor space vents automatically
after a short time in operation. This may cause
noises. If necessary, switch off and on repeat-
edly to accelerate the venting. Dry running for
short periods will not harm the pump.
Page 2
Page 2
WILO SE 02/2021