Nylon Cutting Head - Makita DUR182L Manual De Instrucciones

NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.

Nylon cutting head

NOTICE:
Do not attempt to bump feed the head while the
•
trimmer is operating at a high RPM. Bump feeding
at a high RPM may cause damage to the nylon
cutting head.
The bump feed will not operate properly if the
•
head is not rotating.
013811
The nylon cutting head is a dual grass trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating at a
low RPM.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance."
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the trimmer. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
1. Most effective
1
cutting area
For Model DUR183L
1
1
013831
To mount the attachment to a power unit:
1. Make sure that the lever is not tightened.
2. To open the entrance of the joint, depress the
joint cover.
5
2
3
013832
3. Align the protrusion on the pipe (cutting tool side )
with the concave portion of the joint part.
4. Insert the attachment pipe into the joint part.
Make sure that the surface of the lock lever is
horizontal to the pipe.
5. Tighten the lever firmly as shown.
To remove the attachment, loosen the lever, press the
front part of the lock lever and then slide the pipe.
Installing the grip
2
2
3
4
014155
Fit the grip onto the shaft pipe and tighten it with two
hex bolts. Make sure that the spacer on the shaft pipe is
located between the grip assembly and the other grip.
Do not remove or shrink the spacer.
CAUTION:
For model DUR183L, never install the grip on the
•
joint.
10
1. Joint
2. Lock lever
2
3. Joint cover
3
4. Lever
2
5. Pipe (Cutting
4
tool side)
5
1. Lock lever
2. Concave portion
1
3. Protrusion
4
3
1. Grip
1
2. Hex bolts
3. Cover
4. Clamps
5
5. Cutting tool side
6. Spacer
6