Storing The Machine; Troubleshooting; Disposing Of The Machine - BM2 BIEMMEDUE MOBILE Serie Manual De Uso Y Mantenimiento

9 Storing the machine

9.1 Storing the machine
If the machine is not used for long periods, protect exposed parts
(not protected by paint, surface treatment or plastic) with protective
rust prevention oils. If the machine is not to be used for particularly
long periods, you should also clean it thoroughly. After performing
these operations, seal the machine inside an opaque black
multilayer nylon bag together with a suitable drying agent (silica gel).
For instructions regarding the engine follow the instructions
described in the manual for use and maintenance of the installed
engine.
10 Disposal
10.1

Disposing of the machine

At the end of its working life, the machine must be scrapped and
disposed of by taking it to a local differentiated waste collection
centre in compliance with current legislation which must be followed
scrupulously. Before disposing of the machine, check the machine
rating plate. If it bears the
regulated by EC directive 2002/96 on Waste Electrical and
Electronic Equipment,
information on the local electrical and electronic products collection
system and follow the instructions. Disposing of this product illegally
in the household waste could cause serious damage to the
environment and human health and you may be liable to sanctions
from the local authority.
11 Table of regular maintenance
For periodic maintenance of the internal combustion engine, follow
the rules outlined in the manual of use and maintenance of the
installed engine.
OPERATION
Check the functioning of all
controls
Check connector gaskets
Check oil level in the pump
symbol, this means its disposal is
WAEE. You should therefore
X
X
X X

12 Troubleshooting

The table below gives the most common problems which may arise
during normal use of the high pressure washer.
These problems are easy to resolve with operations classified as
routine maintenance If the problem is not present in the following
table or cannot be eliminated following the instructions here, contact
customer service.
PROBLEM
The machine does
not start up
Irregular
operation
Inadequate
pressure
Vibrations
seek
abnormal
discharge
Pump noisy
"White" oil
Water leaks
CAUSE
Fuel is absent or
insufficient
Other
engine Examine
carefully before
any attempt
Nozzle blocked
or distorted
Valve dirty or
worn
and/or The pump is
water sucking in air
Air in the hoses
Pump gaskets
worn
Suction delivery
valves blocked
Bearings worn
Seepage of
water into the oil
(emulsion)
Gaskets and/or
pistons worn
REMEDY
Check the level and
fill if necessary
Refer to engine
manual use and
maintenance
Contact customer
service
Clean or replace
Contact customer
service
Check water supply
connectors
Vent the air by
disconnecting the
hose
Contact customer
service
Unscrew valve caps,
remove and clean
(ideally contact
customer service)
Contact customer
service
Have the seal pack
replaced by
customer service
Have the seal pack
replaced by
customer service