Tabla de contenido
Publicidad
Safety
Signs, symbols and instructions placed on this
product must never be covered or removed and
must remain present and clearly legible throughout
the entire lifetime of the product. Immediately
replace or repair illegible or damaged signs, symbols
and instructions. Contact your local dealer for
instructions.
In case of an adverse event occurred in relation to
the device, incidents should be reported to your
local dealer and the national competent authority
in a timely manner. The local dealer will forward
information to manufacturer.
Caregiver
•
Read the "User Guide" carefully before use
and keep it for future reference. Incorrect use
of this product may cause serious injury to the
user
•
This product contains small parts which could
present a choking hazard if removed from their
intended placing
•
Always use the correct lifting techniques and
aids for this purpose
•
Never leave the user unattended in this
product. Ensure permanent supervision by an
adult
•
Repair/replacements must only be made using
new original R82 spare parts and fittings and
carried out in accordance with the guidelines
and service intervals prescribed by the supplier
•
Be aware of any MAX mark indications before
adjustment
•
Ensure that moving parts does not squeeze or
trap body parts when adjusting them
•
If there is any doubt as to the continued safe
use of your R82 product or if any parts should
fail, stop using the product immediately and
contact your local dealer as soon as possible
•
Always use the product in a moderate pace. Do
not run with the product
•
Information about transportation can be found
in the document "Transportation in Motor
Vehicles" supplied with the product
•
Information about roadability can be found in
the document "Roadability" supplied with the
product
Environment
•
Observe the surface temperature on the
product, before placing an user in it. This goes
especially for users with insensitive skin as they
cannot feel the heat. If the surface temperature
is above 41°C then allow the product to cool
before use
User
•
If the user is close to the max. load limit and/
or has a lot of involuntary movements, e.g.
rocking, a larger size with a higher max. load or
a different R82 product should be considered
•
For transportation the product is suitable
for children in the weight range of 22 kg to
specified max user weight for transportation
support.R82.org
Product
•
Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of the
reach of children
•
Ensure the stability of the product is
maintained before placing the user in it
•
Activate the brakes before placing the user into
the product
•
Activate the anti-tips before angling the seat
and back
•
Deactivate the anti-tips when forcing kerbs
higher than 100 mm
•
We recommend you notify the user before
angling the seat and back
•
Ensure the wheels are fully-functional and
secure before use
•
Do not expose the gas spring to pressure or
high temperatures. DO NOT puncture
•
Inspect the product and all of its accessories
and replace any worn out parts before use
•
This product is tested for resistance to ignition
at level non-ignition in accordance with EN
1021-1, EN 1021-2 and ISO 7176-16
• The product might lose its flame resistant
characteristics if using other than original
R82: Cushions
Service information
Maintenance of a medical device is wholly the
responsibility of the owner of that device. Failure
to maintain a device in accordance with the
instructions may invalidate the device's warranty.
Furthermore, failure to maintain a device may
compromise the clinical condition or safety of users
and/or their caregivers. Do not perform service and
maintenance while the user is in the product.
1st Day
•
Read the User Guide carefully before use and
store it in a safe place for future reference
•
Store the enclosed tools on/at the product
Daily
•
Use a dry cloth to clean the product
•
Visual inspection. Repair or replace any
damaged or worn-out parts
•
Ensure that all fasteners are in place and fitted
correctly
•
Check all fittings and buckles for signs of worn
out parts
•
Be aware of any MAX mark indications before
adjustment
Weekly
•
Check that all wheels are moving freely and
that all wheel locks/brakes are easily activated
•
Wipe off any residue and dirt from the product
using a cloth with warm water and a mild
detergent/soap and dry before use
•
Disinfect the product. please check the
disinfection section in this User Guide for more
information
•
Tire pressure
37
EN
Publicidad
Tabla de contenido
