Using The Unit; Working Technique - Stihl HSE 42 Manual De Instrucciones

3 Using the Unit

Never attempt to modify your power tool in any
way since this will increase the risk of personal
injury.
Regularly check that the insulation of the power
cord and plug is in good condition and shows no
sign of ageing (brittleness).
Electrical components, e.g. power cord, may only
be repaired or replaced by a qualified electrician.
Clean plastic components with a cloth. Do not
use aggressive detergents. They may damage
the plastic.
Do not spray the machine with water.
Check tightness of mounting screws on safety
devices and the cutting attachment and retighten
if necessary.
Clean cooling air inlets in motor housing as nec‐
essary.
Store the machine is a safe and dry place.
3 Using the Unit
3.1 Cutting Season
Observe country-specific or municipal rules and
regulations for cutting hedges.
Do not use your power tool during other people's
rest periods.
3.2 Cutting Sequence
Use lopping shears or a chain saw to cut out
thick branches first.
Cut both sides of the hedge first, then the top.
3.3 Disposal
Do not throw cuttings in the garbage can – they
can be composted!
0458-762-9821-C
3.4

Working Technique

3.4.1 Vertical Cut
Swing the cutting blade from the bottom upwards
in an arc – lower the nose of the blade, move
along the hedge and then swing the blade up
again in an arc.
Any working position above head height is tiring.
To minimize the risk of accidents, work in such
positions for short periods only.
English
21