Mounting Polymer Blades; Mounting The Loop Handle - Stihl FSA 45 Manual De Instrucciones

11 Assembling the Trimmer
► Repeat the mounting process on the other side of the
mowing head with the second length of line.
► Cut the trimmer line so that it extends to the line limiting
blade.
NOTICE
Using the trimmer with overly long trimmer line increases the
load on the motor and reduces its operating speed. This may
result in overheating and damage to important components.

11.2.2 Mounting Polymer Blades

WARNING
Use of metal cutting attachments, wire or metal-reinforced
line is not authorized and could be extremely dangerous.
Use only the cutting attachments recommended in this
manual, in combination with the recommended deflector,
@ 5.7.4.
WARNING
A damaged or loose cutting attachment or mowing head may
vibrate, crack, break or come off the trimmer, which may
result in serious or fatal injury. Make sure the mowing head
and cutting attachment are properly tightened and in good
condition before starting work, @ 5.7.4.
To mount the PolyCut 2 - 2 polymer blades on the mowing
head:
► Switch off the trimmer, @ 14.2.
► Remove the activation key, @ 13.2.
0458-718-8621-A
2
1
1
► Position the large hole in the polymer blade on the
mounting post (see illustration).
► Pull the polymer blade (1) outward until the mounting
post (2) locks in the small hole in the polymer blade.
► Repeat the mounting process on the other side of the
mowing head with the second polymer blade.
Always ensure that both cutting blades are properly
mounted before starting work. Operating the trimmer with
only one blade will reduce cutting performance and may
damage the trimmer.

11.3 Mounting the Loop Handle

WARNING
To reduce the risk of injury from loss of control, ensure that
the loop handle is properly mounted and adjusted before
starting work.
To mount the loop handle:
► Switch off the trimmer, @ 14.2.
► Remove the activation key, @ 13.2.
English
2
21