Using The Trimmer; Before Operation - Stihl FSA 45 Manual De Instrucciones

English
– Do not attempt to repair, open or disassemble the
trimmer. There are no user-serviceable parts inside.
￭ If the integrated battery is damaged, battery fluid can leak
out of the trimmer. Leaking battery fluid can cause skin
and eye irritation or chemical burns.
– Avoid contact with skin and eyes.
– Use an inert absorbent such as sand on spilled
liquids.
– In the event of accidental contact, immediately rinse
the contact area thoroughly with mild soap and
water.
– If fluid gets into your eye(s): Do not rub. Rinse water
over the open eye(s) for at least 15 minutes and
seek medical attention.
￭ A battery fire can be dangerous. To reduce the risk of
severe personal injury and property damage in the event
of fire:
– Evacuate the area. Fire can spread rapidly. Stay
clear of any vapors generated and maintain a safe
distance.
– Contact the fire department.
– Although water can be used to put out a battery fire,
use of a multi-purpose dry chemical fire extinguisher
is preferable.
– Consult the fire department regarding proper
disposal of the burned battery.
10
5 IMPORTANT SAFETY INSTRUCTIONS
5.7

Using the Trimmer

5.7.1

Before Operation

WARNING
￭ Misuse or unauthorized use may result in personal injury
and property damage.
– Use the trimmer only as described in this instruction
manual.
￭ For proper assembly of the cutting attachment, deflector
and handle:
– Read and follow the instructions on mounting the
cutting attachment, deflector and handle, @ 11.
￭ The cutting attachment and deflector must be an
approved combination. Before replacing:
– Read and follow the instructions on selecting the
proper cutting attachment and deflector, @ 24.1.
￭ The cutting attachment must be properly installed and
tightened before starting work. Failure to use the proper
parts to mount the cutting attachment may cause the head
to fly off and seriously injure the operator or bystanders.
– Never mount a cutting attachment to the trimmer
without the proper installation of all required parts
(e.g., nuts, screws, thrust washer, thrust plate, etc.).
– Before starting work, inspect for loose parts (nuts,
screws, etc.) and for cracked or damaged heads.
– Replace damaged heads before using the power
tool.
0458-718-8621-A