Publicidad
housing and insert the T-Connector ends with the green
wires between the seperated ends.
10. Route the 12 gauge black wire from the battery
compartment under the vehicle along the frame to a position
near the left (drivers) side tail light housing and the T-
Connectors black box (Fig. 2). Secure the wire to the vehicle
using cable ties (included).
Caution: When routing wire through metal or other
Fig 2
sharp surfaces, always utilize an existing grommet, provide a
grommet or insulate the wire from the hole with silicone rubber.
11. Strip 5/16" of the insulation from one end the inline fuse holder
(included) and attach the 3/8" ring terminal using a crimping tool or pliers.
12. Connect the opposite end of the fuse holder to the black 12 ga. wire
using the yellow butt connector provided. Strip 5/16" of insulation from each
before connecting.
13. With the fuse removed, attach the 3/8"
ring terminal to the vehicles positive (+) battery
terminal (Fig. 3).
Warning: Do not attempt to connect the
black power wire to the vehicle fuse panel
or any other accessory wiring. Failure to
Fig 3
connect
directly to the vehicle battery could cause vehicle damage and/or
trailer lighting failure.
14. At the rear of the vehicle, Strip 5/16" of insulation from the black 12 ga.
wire and connect it to the blue wire using the yellow butt connector on the
converter wire.
15. Reattach the vehicles Negative (-) battery wire.
16. Place the 10 amp fuse into the fuse holder installed in step 12.
17. Confirm trailer harness operation with a test light or by using a trailer.
18. Secure all wires using cable ties (provided). The
T-Connectors black box should be secured behind the left (drivers) side tail
light housing.
19. Re-install both tail light assemblies using the fasteners removed in step 2.
Publicidad
