Acoustic Safety - Motorola Solutions PMMN4050 Manual De Instrucciones

To replace the cord (reassembly):
1. Plug the new coil cord connector plugs into the circuit
board connector jacks.
2. Place the new cord strain relief into the front housing.
3. Replace the rear housing. Make sure that the seal and
housings are properly aligned.
4. Replace the screws into the rear housing and tighten
firmly. Do not overtighten.

ACOUSTIC SAFETY

Exposure to loud noises from any source for extended
periods of time may temporarily or permanently affect your
hearing. The louder the radio's volume, the less time is
required before your hearing can be affected. Hearing
damage from loud noises is sometimes undetectable at
first and can have a cumulative effect.
To protect your hearing:
• Use the lowest volume necessary to do your job.
• Increase the volume only if you are in noisy
surroundings.
• Reduce the volume before connecting headset or
earpiece.
• Limit the amount of time you use headsets or earpieces
at high volume.
• When using the radio without a headset or earpiece, do
not place the radio's speaker directly against your ear.
6