Fitting And Removing Abrasive Tools - Berner BACAGXB 18V Manual Original

used any more under any circumstances and
must be sent to the after-sales service.
Note: The coding cams on the protective guard
(9) ensure that only a protective guard that is suit-
able for the power tool can be fitted.
Protective guard for cutting
Always use the protective guard for cutting
u
(11) when cutting bonded abrasives.
Provide sufficient dust extraction when cut-
u
ting stone.
The protective guard for cutting (11) is fitted in
the same way as the protective guard for grinding
(9).
Extraction guard for cutting with a guide block
The extraction guard for cutting with a guide
block (21) is fitted in the same way as the protect-
ive guard for grinding (9).
Side handle
English
Do not operate your power tool without the
u
side handle (8).
Screw the side handle (8) on the left or right of
the machine head depending on how your are
working.
Low-vibration auxiliary handle
and more comfortably.
Do not make any alterations of any kind to
u
the auxiliary handle.
Do not continue to use a damaged auxiliary
handle.
Hand guard
English
Always fit the hand guard (15) when working
u
with the cup brush/disc brush (19) or diamond
core cutter (20).
Attach the hand guard (15) to the auxiliary handle
(8).

Fitting and removing abrasive tools

Remove the battery from the power tool be-
u
fore carrying out work on the power tool (e.g.
maintenance, changing tool, etc.). The bat-
tery should also be removed for transport and
storage. There is risk of injury from unintention-
ally pressing the on/off switch.
Do not touch grinding and cutting discs until
u
they have cooled down. The discs can be-
come very hot while working.
Only use original X-LOCK application tools that
u
carry the X-LOCK logo. A maintained clamping
gauge of max. 1.6 mm can only be guaranteed
with original X-LOCK application tools. A higher
clamping gauge can lead to insecure clamping,
22 | English
English
English
English
The low-vibration auxil-
iary handle reduces vi-
bration, enabling the
tool to be used safely
English
potentially causing the clamp tool to come
loose.
X-LOCK application tools do not need addi-
u
tional clamping flanges or support flanges.
Make sure that the application tool and the
u
holder are not deformed and are free from dirt
and particles.
Pay attention to the dimensions of the abrasive
tools.
Make sure that both X-LOCK catches are open
(see figure below) before fitting the X-LOCK ap-
plication tool.
If necessary, clean the area between the two X-
LOCK catches.
Fitting the abrasive tool
English
➊ Place the grinding/cutting/flap disc in a cent-
ral position on the X-LOCK holder, parallel to
the bearing surface and with the right side fa-
cing up.
➋ Push the disc into the holder.
➌ The disc audibly clicks into place. Do not ac-
tuate the lever (3) when doing so.
(3)
After fitting, check that the edge of the abras-
u
ive tool (➍) is fitted correctly, i.e. is no higher
than the reference surface (➎). If the edge is
higher than the reference surface, either the
holder must be cleaned or the abrasive tool
must not be used.
Before removing the grinding/cutting/flap disc:
Make sure that the power tool has come to a com-
plete stop.
1 609 92A 5K8 • 29.6.20