Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
servicing the power tool and application tools,
keeping the hands warm, and organising work-
flows correctly.
Fitting
English
Charging the battery
Use only the chargers listed in the technical
u
data. Only these chargers are matched to the
lithium-ion battery of your power tool.
Note: The battery is supplied partially charged. To
ensure full battery capacity, fully charge the bat-
tery in the charger before using your power tool
for the first time.
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging process does not damage the battery.
The lithium-ion battery is protected against deep
discharge by the "Electronic Cell Protection
(ECP)". When the battery is discharged, the power
tool is switched off by means of a protective cir-
cuit: The application tool no longer rotates.
Do not continue to press the On/Off switch
u
after the power tool has automatically
switched off. The battery can be damaged.
Follow the instructions on correct disposal.
Removing the Battery
The battery (6) is equipped with two locking levels
to prevent the battery from falling out if the battery
release button (7) is pressed unintentionally. As
long as the battery is inserted in the power tool, it
is held in position by means of a spring.
To remove the battery (6), press the release but-
ton (7) and pull the battery out of the power tool.
Do not use force to do this.
Battery charge indicator
The green LEDs on the battery charge indicator
indicate the state of charge of the battery. For
safety reasons, it is only possible to check the
state of charge when the power tool is not in oper-
ation.
Press the button for the battery charge indicator
to show the state of charge. This is also possible
when the battery is removed.
If no LED lights up after pressing the button for
the battery charge indicator, then the battery is
defective and must be replaced.
1 609 92A 5K8 • 29.6.20
English
English
English
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Fitting protective equipment
Remove the battery from the power tool be-
u
fore carrying out work on the power tool (e.g.
maintenance, changing tool, etc.). The bat-
tery should also be removed for transport and
storage. There is risk of injury from unintention-
ally pressing the on/off switch.
Note: If the grinding disc breaks during operation
or the holding fixtures on the protective guard/
power tool become damaged, the power tool
must be sent to the after-sales service immedi-
ately; see the "After-Sales Service and Application
Service" section for addresses.
Protective guard for grinding
power tool and rotate the protective guard until it
audibly clicks into place.
Adjust the position of the protective guard (9) to
meet the requirements of the operation. To do
this, push the unlocking lever (1) upward and ro-
tate the protective guard (9) into the required pos-
ition.
Always position the protective guard (9) such
u
that all three red cams on the unlocking lever
(1) engage in the corresponding openings on
the protective guard (9).
Adjust the protective guard (9) such that
u
sparking in the direction of the operator is
prevented.
The protective guard (9) must only be ad-
u
justable while the unlocking lever (1) is actu-
ated. Otherwise, the power tool must not be
Capacity
60−100 %
30−60 %
5−30 %
0−5 %
English
English
Place the protective
guard (9) onto the
holder on the power
tool until the coding
cams of the protective
guard are aligned with
the holder. When do-
ing so, press and hold
the unlocking lever (1).
Press the protective
guard (9) onto the
spindle collar until the
shoulder of the pro-
tective guard is sitting
on the flange of the
English | 21
Publicidad
Tabla de contenido
