Cd Operation - auna US-10032056 Manual Del Usuario

EN
14

CD OPERATION

PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to read all
commercial CDs. It will also read self-compiled MP3,CD-R/CD-RW discs,
but it may take up to 10 seconds for the actual playback to begin. If playback
does not start, it is likely due to the quality of the CD-R/RW disc and/or
the compatibility of the CD compilation software. The manufacturer is not
responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may
cause a malfunction.
PLAY MODE
1. Slide the FUNCTION SWITCH to the "CD/USB" position. The LCD
DISPLAY will light.
2. Open the CD DOOR, load a CD with the label side facing upward and
then close the CD door. A few seconds later the total number of tracks
on the CD will appear on the LCD display.
Press the PLAY/PAUSE
track. The PLAY/PAUSE PLAY (
3. While playing, press the BUTTON once to pause, the unit will go to
pause mode and the PLAY () icon and number of track will be flashing.
4. Adjust the VOLUME CONTROL to the desired volume level.
5. Press STOP () BUTTON to stop playing.
6. T o turn off the CD player, slide the FUNCTION SWITCH to "OFF" position.
The LCD DISPLAY will go off.
NOTE: If skipping occurs during CD play, try turning the volume down.
Do not open the CD DOOR when a CD is playing.
FOLDER MODE (CD/MP3/USB)
1. If the FOLDER buttons is pressed quickly during PLAYBACK/PAUSE/
STOP mode, it will go to the next folder and display the folder number.
2. If the FOLDER buttons is pressed and held during PLAYBACK/PAUSE/
STOP mode, it will go to the next 10 tracks and display the track number.
REPEAT MODE (REPEAT/REPEAT ALL/REPEAT OFF)
1. Press the "PLAY MODE" button one time during playback or pause mode,
will be displayed with flashing, and the current single track will be
 BUTTON to start playing the CD from the first

 ) icon will be displayed.
