Jacuzzi PROJECTA lagoon 170x70 Instalación Uso Y Mantenimiento página 18

Hydromassage
Turn on the main switch and wait a few seconds until the
start-up process has completed.
To start the hydromassage, press the button located at the
edge of the tank; press it again to turn off the function.
We recommend leaving the hydromassage active for a dura-
tion of 15-20 minutes (5-10 minutes are necessary before the ac-
tion of the moving water begins to take effect).
We recommend setting the water temperature at approxi-
mately 36 °C; in the instance of higher temperatures, it is advis-
able to reduce the duration of the hydromassage:
34-36 °C --> 20 minutes of hydromassage
36-38 °C --> 15 minutes of hydromassage
38-40 °C --> 10 minutes of hydromassage
5-6 cm
1
3
Soap and bath foams (where not used as part of hydromas-
sage) must only be used when the hydromassage is not in use.
Always turn off the hydromassage and main switch before
emptying the tub.
WARNING! If there is a power outage, turn off the main
switch. This prevents the pump from accidentally
starting again once power has been restored.
WARNING! Do not press the button on the side of the
tub if the main switch is off. When the main switch is
turned on again, the pump may start accidentally.
WARNING! Do not use the pump if there is no water or
an insufficient level of water.
Sanitization
We recommend the J-MX 07 liquid, offered by Jacuzzi and available
at the Assistance Centres/Authorised Retailers, is used to clean the
tub hydraulic circuit (approximately once a month dependent on
how often the hydromassage is used).
18
on/off
2
4