Honeywell HOWARD LEIGHT IMPACT PRO Instrucciones Para El Usuario página 3

A. B.
AU NZ
USER INSTRUCTIONS
The IMPACT PRO amplifies surrounding sounds such as voices, machines and warning signals to safe levels
®
yet it provides good hearing protection. Loud impulse sounds are effectively blocked out and limited to safe
levels. The unique stereo microphones (3) allow detection of the direction of ambient sounds, enhancing com-
munication abilities and awareness of surroundings. This earmuff is provided with electrical audio jack input
for connection with MP3 players, cell phones and radio scanners.
INSTRUCTIONS FOR FITTING according to illustrations: Open the battery lid (1) by pushing the lid up with your
thumbs. Let it slide off of the ear cup. Insert the two enclosed 1.5 V AAA batteries. Make sure that the + and –
poles are in the correct position. Ensure that the battery lid is closed completely.
1. Extend the headband before use.
2. Place the earcups over the outer ear (picture A), on/off wheel on the left side.
3. Adjust the crown headband by moving it up and down in the side headbands (picture B). The ear cushions
should seal firmly against the head (picture C).
For best results, remove all hair under the cushion. Noise reduction will be adversely affected by anything that
impairs the seal of the earmuff cushions against the head, such as thick spectacle frames, hats, etc.
IMPORTANT USER INSTRUCTIONS:
The earmuffs should be fitted, adjusted and maintained in accordance with the instructions. The earmuffs should
be worn at all times in noisy surroundings. The earmuffs should be regularly inspected for serviceability. The
earmuffs should be cleaned and disinfected with soap and warm water. They must not be dipped into water.
Earmuffs and in particular cushions may deteriorate with use and should be examined at frequent intervals
for signs of wear, for example, cracking or sound leakage. Replacement cushions are available. For cushion
replacement, just pull off the old ones and snap in the new ones. To order new ear cushions please see informa-
tion about the hygiene kit. The fitting of hygiene covers to the cushions may affect the acoustic performance of
the earmuffs. Before and after usage, store in a dry place. The temperature should not exceed +55°C (130°F).
The product may be adversely affected by certain chemical substances. Further information should be sought
from the manufacturer. The earmuff is provided with electronic restoration of surrounding sound. The wearer
should check for correct operation before use. If distortion or failure is detected, the wearer should refer to the
manufacturer's advice for maintenance and replacement of the batteries. The output signal of the sound restora-
tion circuit of this hearing protector does not exceed the values known to constitute a risk to hearing. For the
estimation of the effective attenuation of this earmuff, the additional noise emission by the sound amplification
should be taken into account. The estimated A-weighed noise level under the earmuff in passive mode should
not be greater than 82 dB(A). The microphone's wind protector, which eliminates wind noise etc., should be
kept clean. This earmuff is provided with an electrical audio input jack. The wearer should check for correct
operation before use. If distortion or failure is detected, the wearer should refer to the manufacturer's advice.
If the above mentioned recommendations are not followed, the protection and function afforded by the earmuffs
may be severely impaired.
Auto shut-off function 4 hours: After automatic shut-off, wait 5 seconds, turn earmuff on again to get another
4 hours of working time.
C.
BATTERY REPLACEMENT: Open the battery lid (1) by pushing on the sides of battery lid, then slide upward with
your thumbs. Remove the old b atteries by using a blunt tool to gently pry batteries up and out of the battery
compartment. Insert two new 1.5 V AAA alkaline batteries into the battery compartment (1) in accordance with
the instructions inside the compartment. Ensure that the battery lid is closed completely. Warning – performance
may deteriorate with battery usage. Change the batteries whenever the sound reproduction is weakened or
impaired. New alkaline batteries provide approximately 350 hours of operation.
TECHNICAL DATA: IMPACT PRO - Headband earmuff
Material of headband: Steel, Vinyl, Polypropylene
Material of ear cushion: PVC and Polyurethane
Replacement 3.5mm cable No. 1017210
Hygiene kit Model No. 1030220 Foam filled replaceable ear cushions.
WARNING: The output of the electrical audio circuit of this hearing protector may exceed the daily limit sound
level. When exceeding the specified limits a risk of h earing impairment exists. The audibility of warning
signals at a specific workplace may be impaired while using the entertainment facility.
WARNING: Listening to music, or any other sound, at a high volume over time can cause permanent
damage to your hearing. Noise-induced hearing loss can occur even when you are enjoying music on
a p ersonal l istening device. Exposures to high volume over time can cause permanent damage. Users should
enjoy their f avorite music safely and avoid p otential hearing loss. When it comes to safe use of personal listening
devices, we r ecommend that you listen responsibly, i ncluding listening at no more than 80% of a device's maxi-
mum volume for a maximum of 90 minutes per day at such levels. If you listen at a lower volume, you can listen
for a longer time. By contrast, at higher volumes, you should listen for a shorter time. Noise-induced hearing
loss is 100% permanent, but 100% preventable. The user is responsible for the proper selection, use, care
and maintenance of this device. Improper s election (including under/over protection), use or maintenance may
lead to serious hearing loss. If there are any questions concerning this product, contact your safety s upervisor
or Sperian Hearing Protection, LLC.
WARNING: The output of the level-dependent circuit of this hearing protector may exceed the external
sound level.
AU/NZ ONLY - PRODUCT WARRANTY INFORMATION: Any claim under this warranty must be made within 12
months of the date of purchase of the product. To make a claim under the warranty, take the product (with proof
of purchase) to the store where you purchased the product or contact Honeywell Safety Products Australia Pty Ltd.
Honeywell Safety Products Australia Pty Ltd will pay your reasonable, direct expenses of claiming under this
warranty. You may submit details and proof of your expense claim to Honeywell Safety Products Australia Pty
Ltd for consideration.
This warranty is given by Honeywell Safety Products Australia Pty Ltd ABN 61 002 548 272.
Address: 43 Garden Boulevard, Dingley, Victoria, Australia. Ph: 1300 139 166.
E-mail: HLSHSPAMelbourne@honeywell.com
This warranty is provided in addition to other rights and remedies you have under law: Our goods come with
guarantees which cannot be e xcluded under the Australian Consumer Law. You are entitled to replacement or
refund for a major failure and to compensation for other reasonably f oreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
The use of the WEEE Symbol indicates that this product may not be treated as household waste. By ensuring
this product is disposed of correctly, you will help protect the environment. For more detailed information
about the recycling of this product, please contact your local authority, your household/industrial waste
disposal service provider or the shop where you purchased the product.