Bell & Ross BR03-93 GMT BR-CAL.303 Noticia Técnica página 5

STRAP MOUNTING
Attachments (H) with screws on the outer face of the lugs
The 4 socket head screws (hexagon socket/1.3 mm
diameter) mount the strap to the case attachments.
These screws must be handled carefully, using the
2 tools supplied with the watch in its box.
Attachments (H) with no visible screws
A spring bar is used to fit the strap to the case attach-
ments. This bar must be removed carefully using the
5
appropriate tool provided with the watch in the box.
IMPORTANT
. As with all mechanical watches with a date function,
*Quickset date setting
quickset date setting (crown in position 1) MUST NOT UNDER ANY CIRCUM-
STANCES be carried out between the times of 9 P .M. (21:00) and 3 A.M. (03:00).
Magnetic fields . Magnetic fields can adversely affect the accuracy of your watch.
Also, we would recommend that you avoid placing your watch near electronic
devices that may generate large magnetic fields (radio, smartphone, television,
computer, tablet, loudspeakers etc.).
. Once the watch is set, to ensure perfect water resistance, push
Water resistance
the crown back to position 0. Never operate the crown underwater.
Note : The 4 slotted screws (E) mount the bezel to the case and ensure the water
resistance of the watch. To benefit from the Bell & Ross warranty, these screws
must never be unscrewed.
MAINTENANCE
After being immersed in seawater, it is recommended to carefully rinse off the
watch and strap with fresh water. It is also recommended to have the water resist-
ance of your watch checked every two years. To ensure a service that meets the
brand's exacting standards, any servicing of your watch must be carried out by the
Bell & Ross service centre or a watchmaker approved by Bell & Ross. Whenever
repairs are made during the warranty period, you must present the Bell & Ross
warranty card, duly dated and signed by the retailer at the time the watch was
purchased.
ENGLISH