Maintenance - Franke SM 86 P Manual De Instalación Y Servicio

EN
Using the pyrolytic cycle
X X
Rotate the function selector
to the position
„ „
On the display, appears the indication
„ECO„ or „SUP„.
„ „
The preset time is 90 min, this can
be varied from 90 min (Eco mode) to
20 min (Sup mode) via the programmer
(setting button „ + „ or „ - „).
„ „
If the oven is very dirty, it is recommend
o increase the time to 120 min, if
the oven is moderately dirty reduce
the cleaning cycle time to 90 min.
X X
It is possible to defer the start time
of the pyroclean cycle by changing the END
time via the programmer.
X X
After few minutes, when the oven
reaches a high temperature, the door
locks automatically. the pyroclean cycle
can be stopped at any time by turning
the function selector back to ‚0' (the word
OFF will be displayed for 3 seconds).
X X
Once the pyroclean cycle is finished,
the pyrolysis will switch off automatically.
„ „
On the display appears the indication
„END" until the door is locked then
„0--n".
X X
You can turn the function selector back
to „ 0 „ but if the temperaure is still high,
the „0--n „ indication appears to inform that
the door is locked.
Use of pyrolytic cycle in Touch Control
ovens
X X
Rotate the function selector into position
pyrolisys.
„ „
The display will show either „ECO"
or „SUP".
X X
The pre-set time is 90 minutes but it can be
varied from 90 min (Eco mode) to 120min
(Sup mode) using the programmer („ +" or
„-" key).
„ „
If the oven is very dirty, the time
should be increased to 120 min, while
if the oven is only a slightly dirty,
reduce the cleaning cycle to 90 min.
.
SM 86 P

Maintenance

Removal of the oven window
X X
Open the front window.
X X
Open the clamps of the hinge housing
on the right and left side of the front window
by pushing them downwards.
X X
Replace the window by carrying out
the procedure in reverse.
A
Removal and cleaning of the glass door
X X
Open the oven door.
X X
Lock the hinges, remove the screws and
remove the upper metal cover by pulling
it upwards.
X X
Remove the glass, carefully extracting
it from the oven door (note: in pyrolytic
ovens, also remove the second and third
glass (if present)).
X X
At the end of cleaning or substitution,
reassemble the parts in reverse order.
Z X
On all glass, the indication „Pyro" must
be legible and positioned on the left
side of the door, close to the left-hand
lateral hinge. in this way, the printed label
of the first glass will be inside the door.
Changing the bulb
X X
Disconnect the oven from the mains supply.
X X
Undo the glass cover, unscrew the bulb and
replace it with a new bulb of the same type.
X X
Once the defective bulb is replaced, replace
the glass cover.
– 14 –