Selecting The Installation Site - Panasonic R410A Instrucciones De Instalación

2. SELECTING THE INSTALLATION SITE

2-1. Indoor Unit
AVOID:
O
areas where leakage of fl ammable gas may be expected.
O
places where large amounts of oil mist exist.
O
direct sunlight.
O
locations near heat sources which may affect the performance
of the unit.
O
locations where external air may enter the room directly. This
may cause "condensation" on the air discharge ports, causing
them to spray or drip water.
O
locations where the remote controller will be splashed with
water or affected by dampness or humidity.
O
installing the remote controller behind curtains or furniture.
O
locations where high-frequency emissions are generated.
DO:
O
select an appropriate position from which every corner of the
room can be uniformly cooled.
O
select a location where the ceiling is strong enough to support
the weight of the unit.
O
select a location where tubing and drain pipe have the shortest
run to the outdoor unit.
O
allow room for operation and maintenance as well as
unrestricted air fl ow around the unit.
O
install the unit within the maximum elevation difference above
or below the outdoor unit and within a total tubing length (L)
from the outdoor unit as detailed in the installation manual
packed with the outdoor unit.
O
allow room for mounting the remote controller about 1m off the
floor, in an area that is not in direct sunlight or in the flow of
cool air from the indoor unit.
Fig. 2-1
6