Finish Operation; Maintenance And Care - Kärcher BP 1 Barrel Manual De Instrucciones

Preparing the immersion
pump operation
Screw the hose connection G 3/4

(24.4 mm) for the 3/4" (19 mm)
hose onto the pump (not included in
the delivery).
Slide the hose onto the hose con-

nection and fasten it with an appro-
priate hose clamp.
Note:
A short hose and a large hose
diameter yield a high volume.
Illustration
In automatic operation, set the re-

quired switching height by clamping
the level switch cable into the stopper.
Illustration
In manual operations mode, align

the level sensor upward (cable
pointing downward). Tip: Push the
cable of the level sensor like a loop
through the handle.
Operation
The liquid level must at least be 3 cm
for the pump to suck in liquids indepen-
dently.
Insert the mains plug into the sock-

et.
Caution
If the prerequisites for the
pump operation are met (wa-
ter level, position / level
switch), the pump will start
immediately after the mains
plug has been plugged in.
Automatic operation
In the automatic mode, the level switch
automatically controls the pumping op-
erations. The pump switches on or off
when the fluid level reaches the height
that has been set.
Ensure that the level sensor is not ob-
structed in any way.
Open the locking tap to remove wa-

ter (arrow vertical).
Manual operation
In manual opertions the pump remains
switched on continuously.
Open the locking tap to remove wa-

ter (arrow vertical).
Note:
Dry run leads to increased wear
and tear; do not leave the pump
unattended when it is running.
Switch off the pump within 3
minutes of dry running
.
Comfort operation
In order to run the pump independent
of the water level, the level switch must
be mounted inside the housing (Fig. 1).
Rotate the housing with the level

switch in the arrow direction "ON".
The pump will turn on.

Open the locking tap to remove wa-

ter (arrow vertical).

Finish operation

Rotate the housing with the level

switch in the arrow direction "OFF".
The pump will turn off.
Disconnect the main plug from the

socket.

Maintenance and Care

Danger
Turn off the appliance and re-
move the mains plug prior to any
care and maintenance work.
– 5
EN 17